A Dual-Fuel System for Your Germantown Home, Done Right.
A dual-fuel system gives your Germantown home a heat pump for most of the season and a gas or propane furnace for the coldest nights, each doing what it does best. We match the two, set the handoff so they never fight, and lay out the plan and the price before anything begins.
Heat Pump Plus FurnaceSized to Your HomeYou Approve First
That early-1980s to mid-2000s house in Kingsview deserves heat that holds in January. Mora Heating & Air installs dual-fuel systems, pairing a high-efficiency heat pump with a gas or propane furnace on your existing ducts. For an oil home, we add only the heat pump and leave the oil furnace to your oil provider, keeping each trade in its lane.
Last updated November 2026
Understanding Dual-Fuel Systems
Here is the idea in plain terms. A heat pump handles your cooling in summer and most of your heating in winter, because it costs less to run. When it gets cold enough that the heat pump has to work too hard, the thermostat quietly hands off to the gas or propane furnace. You do not flip anything. It just picks the right one.
That handoff point gets set for your home and your equipment, so the system uses the heat pump as long as it makes sense and only leans on the furnace when it really needs to. You feel steady heat the whole time.
What the Installation Covers
We start by looking at your gas or propane furnace, its venting and airflow, to see if it can stay or needs replacing. If it needs replacing, that goes in the scope so there is no surprise. If your home runs on oil, we only add the heat pump and leave the oil furnace to your oil provider. We do not do duct work.
What This Covers
Natural-gas or propane furnace condition, venting and compatibility assessed before the equipment is selected
Review of the existing furnace information and compatible heat-pump options
A heat pump coil matched to the furnace and mounted the right way for it
Equipment connected to the existing ductwork as it is, within the agreed installation scope. We do not alter or add ducts
Compatible equipment wiring and a thermostat with dual-fuel logic, set to the manufacturer instructions
Connection to a compatible existing electrical supply within our scope
Removing air and moisture, testing for leaks and setting the refrigerant amount to the equipment instructions
Permit and inspection requirements, including who handles each step, identified in the written scope
Startup readings, the changeover setting (the outdoor temperature where it switches from the heat pump to the furnace) and a walkthrough of the thermostat
Who It Suits
A home with gas already at the house and a furnace in sound condition
A furnace and air conditioner reaching replacement together, where a heat pump plus furnace pair fits the home
A home where a heat pump and gas furnace can work together with compatible settings
A home where the existing ducts suit the furnace airflow, since we do not alter ductwork
Equipment Options
The proposed heat pump, indoor coil and settings must be compatible with the existing furnace. The written scope identifies the equipment and connection work.
How a Dual-Fuel Installation Runs
We assess the furnace first
The natural-gas or propane furnace condition, venting and airflow help determine whether it can remain or needs a separately approved replacement.
We review the heat-pump and furnace pairing
The proposed heat pump, coil and settings are checked for compatibility with the furnace before ordering.
You get the whole scope in writing
The written scope names the equipment, the settings, the connection work and the sequence.
We install, set the switchover and test
Startup readings and the switchover setting are recorded and explained with you at the thermostat.
Service Close to Home
We serve homeowners in Germantown, Gaithersburg and Montgomery Village. Call or text with the full service address and the work you need so we can confirm the request.
We are local to Germantown, Gaithersburg and Montgomery Village, so we know the homes and the winters here.
Dual-Fuel Installation Built Around Germantown Homes
Germantown winters swing, and a dual-fuel setup suits that. A heat pump carries the milder stretch efficiently, and a gas or propane furnace steps in on the coldest nights, which fits the gas-heated homes that fill most of these neighborhoods.
We match a heat pump to your gas or propane furnace and tie them to the existing ductwork as it is, setting the thermostat so the two hand off at the right point. If your home runs on oil, we only add the heat pump and leave the oil furnace to your oil provider, and we do not alter or add ducts.
Yes. We install dual-fuel heating throughout Milestone in Germantown, in both the townhomes and the single-family homes. Tell us your address and what the system is doing, and we will confirm the request.
We serve Germantown across 20874 and 20876, alongside Gaithersburg and Montgomery Village. Send your full service address when you reach out so we can confirm the request.
Sometimes. The natural-gas or propane furnace condition, approved coil match, airflow and settings must be assessed. Oil-heated homes have a separate limited scope: a compatible heat-pump addition, with oil-furnace service handled by your oil provider.
It is the outdoor temperature where the system stops using the heat pump and switches to the furnace. We set it for your home so you get the lower-cost heat as long as it makes sense.
No. The thermostat has to be able to run both the heat pump and the furnace and hand off between them. We make sure yours can, or include one that does.
Not always. It depends on the equipment, the weather and your electric and fuel rates. We will talk through whether it is the right fit for your home instead of promising a number.
Equipment-specific procedures follow the manufacturer instructions.
What Your New System Is Covered By
Your new system comes with the manufacturer's parts warranty, and that coverage is strongest when the equipment is registered in your name as the original owner. We take care of that registration so your warranty is active from day one, and if you ever need to use it, we will help you through it.
Financing Available
Larger repairs and replacements can be financed. If you would rather spread the cost over time, we can walk you through the options, so comfort and safety do not have to wait on timing.
Get a Quote
Tell Us What You Need.
Tell us what your heating or cooling system is doing. Include the service address and any useful photos taken from a safe distance.
1
Tell us what is happeningDescribe the problem and when it started. Photos of safely accessible equipment can help.
2
We review the detailsWe follow up to understand the equipment and discuss the next step.
3
Review the proposed workYou receive a written scope before work begins. A request alone does not confirm an appointment.
RepairFind the problem
ReplaceCompare the options
MaintainCare for your system
Ask questions before deciding. We explain the findings and proposed work in plain language.
Real reviews from homeowners across Germantown, Gaithersburg and Montgomery Village.
DP
DMV Properties
August 2026
★★★★★
"Over the last 9 years we have hired Mora Heating & Air on multiple occasions to service our HVAC units as well as do many repairs for our rentals and each time it's been easy to communicate, straight forward crew that do what is necessary and our tenants never complain about the process. Will continue using."
Google
RN
Robert Nicolay
September 2026
★★★★★
"This is a good company. They helped me out with my new hvac equipment for three systems in the home. The systems where over 20 years old."
Google
KA
Kathleen Andersen
September 2026
★★★★★
"Went above and beyond, very knowledgeable and thorough. Highly recommend! A+++"